Saneo A010A-12C Manual page 55

2. The room does not cool
down enough.
3.The 'Power Off' function is
in heating mode.
4. Noise
5. E0 code
6. E2/E4 code
6. Code E3
Doors and windows are not
closed.
There are sources of heat in
the room.
The exhaust pipe is not
connected or is blocked.
The set temperature is too
high.
The air inlet is blocked.
When the temperature of
the air outlet is higher than
70 (??), the appliance turns
off automatically.
The appliance has been
placed on a surface that is
not flat.
The noise comes from the
flow of the refrigerant in the
appliance.
The room temperature
sensor does not work.
The water tank is full.
The pipe temperature
sensor does not work.
Close doors and windows.
Remove or switch off the
sources of heat.
Connect the exhaust pipe or
clean it.
Reset the temperature.
Clean the air inlet.
Switch the appliance back
on when the temperature
has fallen.
Place the appliance on a flat
surface.
This is normal.
Replace the
temperature sensor
appliance still works without
the sensor).
Empty the water tank.
Replace the
temperature sensor
appliance still works without
the sensor).
room
(the
pipe
(the