Saneo A010A-12C Manual page 51

Continuous evacuation
-
When the unit is not in use for a period of time, remove the rubber part
from the exhaust outlet underneath the unit and connect the exhaust
hose to the clamp on the bottom of the air conditioner. The water from
the tank drains out. When the air conditioner is in heating mode, this
method can also be used.
-
If the water pump is damaged, this continuous discharge method can be
used. By using this method, the water pump is not activated but the
appliance can be used without issue.
-
If the water pump is damaged, intermittent drainage can be used. When
the "water tank full" indicator light comes on, connect the exhaust hose
to the clamp on the bottom of the air conditioner. The water from the
tank drains out.
-
The air conditioner must be installed on a flat and clear surface. Do not
block the air outlet and the air conditioner must have a diameter of
30cm without objects around it.
-
The unit must be installed in accordance with national electrical
standards.
WARNING