Saneo A010A-12C Manual page 50

11. Cooling function
-
Press the 'Mode' button (function) until the 'Cool' icon appears.
Press the "DOWN" or "UP" button to select the desired temperature.
-
Press the 'Wind' button to select the wind speed.
-
12. Dehumidifiying function
- Press the 'Mode' button (function) until the 'Dehumidify' icon appears.
-The temperature is automatically set 2 degrees lower than the room
temperature.
- The wind speed is automatically set to 'low'.
13. Fan speed
-
Press the 'Mode' button until the 'Fan' icon appears.
Select the fan speed by pressing the 'WIND' button.
-
14. Heating function (this function is not available on this model).
15. Timer function
Timer ON
- When the air conditioner is off, press the 'Timer' button and select the
desired time using the temperature and timer buttons.
- The timer duration (Preset ON Time) is displayed on the control panel.
Timer OFF
- When the air conditioner is on, press the 'Timer' button and select the
time at which you want the unit to turn off using the temperature and
timer buttons.
- The timer duration (Preset OFF Time) is displayed on the control
panel.
16. Air flow
- Turn on the unit and press the "SWING" button to activate this function.
Press the same button again to stop it.
17. Sleep mode
When the air conditioner is in cooling mode, press the "SLEEP" button
to select the temperature. The temperature rises by one degree after
one hour and rises by two degrees after two hours.
Press the "SLEEP" button again to cancel this function.
18. Evacuation
-
The tank is equipped with an indicator light that lights up when the water
level exceeds the maximum level. (If the water pump is damaged,
remove the rubber part from underneath the unit to drain the water).