Installing The Wheel - GEISMAR MP.12 Manual

3.2 – Installing the wheel
Proceed as follows to install the wheel:
■ Disassembling the wheel:
- Lower the wheel as far as it will go (flywheel anti-clockwise direction),
then disassemble the wheel casing Item ② by unscrewing the 2 screws
Item ① (17 wrench) (see fig.1).
- Lock in place the spindle Item ④ using a 23 open-end wrench, then
unscrew the "wheel+wheel-holder" assembly using a second 23 open-end
wrench.
- Separate the wheel Item ⑥ from the wheel-holder plate Item ⑤:
- assembly Fig.2 → Unscrew the fastening screws Item ③ (13 open-
end wrench).
- assembly Fig.3 → Lock in place the wheel Item ⑥, then unscrew
the wheel-holder plate Item ⑤ (23 open-end
wrench).
1
Fig.1
The wheels to use must conform to the
technical characteristics defined in chapter 2.3
– Technical characteristics / Wheel.
Ref. : 450100 FR
5
3
2
Fig.2
The wheel must be installed with the engine stopped and
the machine placed on the ground.
Assembling the wheel:
■
- assembly Fig.2 - Position the wheel Item ⑥ so that its inner Ø bears
on the shoulder of the wheel-holder plate Item
⑤. Place the fastening screws Item ③ on the
wheel Item ⑥ and bring them up until they touch.
Then tighten their screws.
- assembly Fig.3 - Lock in place the wheel Item ⑥, then screw on the
wheel-holder plate Item.⑤ (23 open-end
wrench).
- To reassemble the "wheel+wheel-holder" assembly, carry out
operations 2 and 1 in the reverse order to disassembling.
4
6
Fig.3
The wheels have use-by dates. Ensure
that these dates are not exceeded.
4
6
5
| 27
P a g e