Door Hardware - Handy Home Products MONARCH Assembly Manual

PARTS REQUIRED:
x2
BEGIN
Place bolt onto OO in open position with bolt end 3/8" down from frame.
1
Bolt is open when loop is contacting base (Fig A).
Mark and pre-drill holes for screws.
2
Install bolt with screws supplied and drill 5/16" hole for bolt to extend into.
Place bolt onto OO in open position with bolt end 1/2" up from floor.
3
Bolt is open when loop is contacting base (Fig B).
Mark and pre-drill holes for screws.
Install bolt with screws supplied and drill 5/16" hole for bolt to extend into.
4
LEFT
DOOR
FINISH
You have finished installing your spring bolts.

DOOR HARDWARE

5/16" (0,8 cm) Drill Bit
LOCATE AND PRE-DRILL HOLES TO AVOID SPLITTING WOOD
OVER DOOR FRAME
1-1/4 x 2-1/2 x 69"
OPEN POSITION,
Spring is loose.
Loop contacts
OPEN POSITION,
Spring is loose.
43
Fig. A
OO
x4
base.
FLOOR
1/2"
Fig. B
x8
1" (2,5 cm)
5/16" drill for bolt:
1" deep.
3/8" with bolt in open
position.
PRE-DRILL
(4) HOLES
Loop contacts
base.
1-1/4 x 2-1/2 x 69"
OO
x4
PRE-DRILL
(4) HOLES
5/16" drill for
bolt: 1" deep.