Adjust The Column Tilt; Before Drilling; Drill Motor Spacer Block; Recommended Drill Diameter - Husqvarna DS900 DD Operator's Manual

Adjust the column tilt

The drill column can be tilted, recommended range in use
is 0-60°.
• Loosen the locking screw for column tilt and set the
desired drill angle. Tighten the locking screw.
• The angle indicator can be used for approximate
adjustment. If higher precision is required, alternative
measuring methods should be used.
10 – English
OPERATING

Before drilling

!
!

Drill motor spacer block

(accessory)
A spacer is used in order to drill large diameters. There
are several different versions.
• Assemble the spacer on the drill motor
• Then assemble the drill motor with spacer onto the
stand, see section 'Assembly of drill motor'.

Recommended drill diameter

Max. drill diameter, mm/inches
Drill motor
DM406
DM650
DM280/340
WARNING! Before drilling, check that all
locking screws are tightened well.
Serious accidents can occur if the
concrete core remains in the drill when
backing out the drill motor/drill from the
floor, wall or ceiling.
WARNING! When drilling ceilings, always
use a water collector that is approved for
your drill motor, or use a hydraulic drill
motor. There is a risk that the drilling
machine and the stand become live if
water leaks into the machine.
Spacer block, mm/inch
0 50/2
500/19,7 600/23,6 700/27,6 900/35,4
400/15,7 500/19,7 600/23,6 800/31,5
370/14,6 470/18,5 570/22,4 670/26,4
2x 50/2 200/7,9