Assembly Of Drill Motor; Adjust The Column Tilt; Before Drilling; Transport Wheels - Husqvarna DS 450 Operator's Manual

Assembly of drill motor

IMPORTANT! Always pull out the plug from the outlet
socket before cleaning, maintenance or assembly.
• Always remove the drill bit before the motor is mounted or
dismounted.
• Lock the feed housing lock.
• Fit the drilling machine in the track on the locking clamp.
Make sure that the drilling machine is pushed all the way
to the bottom (A) of the track on the locking clamp. Fasten
the locking clamp with the locking screw (B).
• The adapter plate is mounted on the drill motor. Not used
with Husqvarna's drill motors.

Adjust the column tilt

The column can be tilted 0-75°.
• Loosen the locking screws for column tilt and set the
desired drill angle. Tighten the locking screws.
• The angle indicator can be used for approximate
adjustment. If higher precision is required, alternative
measuring methods should be used.
10 –
English
OPERATING

Before drilling

!
!
Transport wheels (accessory)
• Push the aluminium bail (A) towards to the mounting on
the stand.
• Place the wheel set (B) over the aluminium bail.
• Insert the bolt (C) and fit the nut. Screw the bolt tight.
WARNING! Before drilling, check that all
locking screws are tightened well.
Serious accidents can occur if the concrete
core remains in the drill when backing out
the drill motor/drill from the floor, wall or
ceiling.
WARNING! When drilling roofs, always use a
water collector that is approved for your drill
motor, or use a hydraulic drill motor. There is
a risk that the drilling machine and the stand
become live if water leaks into the machine.