Maintenance - Shark AI Robot VACMOP 2000WD Series Owner's Manual

USING THE SHARK® AI ROBOT VACMOP™
Please visit sharkclean.com/app or call 1-855-460-5425 for answers to all your app questions.
USING THE SHARKCLEAN™ APP AND VOICE CONTROLS
Get the most out of your Shark AI Robot VACMOP with these app features:
• Recharge and Resume
Enable this feature to handle
multi-room cleaning in larger
homes. The robot will return
to the dock, recharge, and
Dining Room
Kitchen
Living Room om
can pick up where it left off.
• Carpet Detection
Once the robot has mapped
your home, activate Carpet
Detection in the app to
identify carpets and rugs for
the robot to avoid when it
mops.
Search for SharkClean in the app store and download the app to your iPhone
SETTING UP VOICE CONTROL WITH THE GOOGLE ASSISTANT OR AMAZON ALEXA
Visit sharkclean.com/app for setup instructions which include how to enable Shark Skill for Amazon Alexa
and using with Google Assistant.
Google Assistant:
"OK Google, tell Shark to start cleaning."
"OK Google, tell Shark to pause my robot."
" OK Google, tell Shark to send my robot to
the dock."
WI-FI TROUBLESHOOTING
• To use the app, your phone must be connected
to a 2.4GHz network. The app will only work on a
2.4GHz network.
• Typical home Wi-Fi networks support both 2.4GHz
and 5GHz.
ERROR CODE
! (RED) + Wi-Fi indicator (RED Flashing)
! (Flashing red) + Wi-Fi (RED)
Wi-Fi (RED Flashing)
s h a r kc l e a n . c o m
• Scheduling
Set whole-home cleanings
for any time, any day.
• Control From Anywhere
Wherever you are, you're in
control of your robot.
• Cleaning Reports
Each time your robot cleans,
your app will generate a
cleaning report.
or Android .
TM TM
Amazon Alexa:
"Alexa, tell Shark to start cleaning."
"Alexa, tell Shark to pause my robot."
" Alexa, tell Shark to send my robot to
the dock."
• Do not use a VPN or a proxy server.
• Make sure Wi-Fi isolation is turned off on the
router.
• If you cannot connect, call 1-855-460-5425.
PROBLEM
Wrong password for Wi-Fi
SSID cannot be found, try connecting again
Cannot connect to Wi-Fi

MAINTENANCE

CAUTION: Turn off power before performing any maintenance.
NOTE: Even when the switch is in the OFF (O) position, the robot still uses a
small amount of power.
EMPTYING THE DUST BIN
With the fluid reservoir removed, press the Dust Bin
Release Button and slide out the dust bin.
Empty debris and dust into trash. Wash dust bin if
necessary, using water only.
NOTE: Make sure to insert the dust bin completely, until
it clicks into place.
To open the dust bin lid, press and hold the button
while lifting the lid, using the finger slots.
To avoid mold, clean the area between the filter
and the plastic shield after every mopping run, and
periodically after vacuuming. Remove the shield
and clear any debris buildup with a dry cloth or
soft brush.
s h a r kc l e a n . c o m