Important Safety Instructions - Shark AI Robot VACMOP 2000WD Series Owner's Manual

IMPORTANT SAFETY INSTRUCTIONS

PLEASE READ CAREFULLY BEFORE USE • FOR HOUSEHOLD USE ONLY
If the charging cable plug does not fit fully into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. DO NOT force into outlet or try to modify to fit.
WARNING
To reduce the risk of fire, electric shock, injury, or property damage:
GENERAL WARNINGS
When using an electrical appliance, basic
precautions should always be followed,
including the following:
1. This appliance consists of a Wet/
Dry Robot Floor Cleaner vacuum and
charging dock with power supply.
These components contain electrical
connections, electrical wiring, and
moving parts that potentially present risk
to the user.
2.
Before each use, carefully inspect all
parts for any damage. If a part is damaged,
discontinue use.
3. Use only identical replacement parts.
See replacement accessories page of this
booklet.
4. This Wet/Dry Robot Floor Cleaner
contains no serviceable parts.
5. Use only as described in this manual.
DO NOT use Wet/Dry Robot Floor
Cleaner for any purpose other than those
described in this manual.
6. With exception of filters, dust cups and
pads, DO NOT expose any parts of the
Wet/Dry Robot Floor Cleaner to water or
other liquids.
USE WARNINGS
7. This appliance can be used by persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way and
understand the hazards involved.
a) Children shall not play with the
appliance.
b) Cleaning and user maintenance shall
not be made by children without
supervision.
8.
Always turn off the robotics vacuum
cleaner before inserting or removing the
filter, dust bin, or fluid reservoir.
9. DO NOT handle plug, charging dock,
charging cable, or Wet/Dry Robot Floor
Cleaner with wet hands. Cleaning and
user maintenance shall not be made by
children without supervision.
s h a r kc l e a n . c o m
10. DO NOT use the robot without the dust
bin, filter, and fluid reservoir in place.
11. DO NOT damage the charging cord:
a) DO NOT pull or carry charging
dock by the cord or use the cord as
a handle.
b) DO NOT unplug by pulling on cord.
Grasp the plug, not the cord.
c) DO NOT close a door on the cord,
pull the cord around sharp corners,
or leave the cord near heated
surfaces.
12. DO NOT put any objects into nozzle or
accessory openings. DO NOT use with
any opening blocked; keep free of dust,
lint, hair, and anything that may reduce
airflow.
13. DO NOT use if Wet/Dry Robot Floor
Cleaner airflow is restricted. If the air
paths become blocked, turn the vacuum
cleaner off and remove all obstructions
before turning on the unit again.
14. Keep all vacuum openings away from
hair, face, fingers, uncovered feet, or
loose clothing.
15. DO NOT use if Wet/Dry Robot Floor
Cleaner is not working as it should,
or has been dropped, damaged, left
outdoors, or dropped into water.
16. DO NOT place vacuum cleaner on
unstable surfaces,
17. If robot is placed in a room, and it is not
starting from the dock, the robot must
be placed in an unobstructed circle of 1.5
ft. (45 cm) away from edges and cliffs.
18. DO NOT use to pick up:
a) Liquid spills
b) Large objects
c) Hard or sharp objects (glass, nails,
screws, or coins)
d) Large quantities of dust (drywall
dust, fireplace ash, or embers).
DO NOT use as an attachment to
power tools for dust collection.
e) Smoking or burning objects (hot
coals, cigarette butts, or matches)
f) Flammable or combustible
materials (lighter fluid, gasoline,
or kerosene)
g) Toxic materials (high
concentrations of chlorine bleach
liquid, high concentrations of
ammonia, or drain cleaning
solution)
19. DO NOT use in the following areas:
a) Outdoor areas near fireplaces with
unobstructed entrances
b) Spaces that are enclosed and may
contain explosive or toxic fumes
or vapors (lighter fluid, gasoline,
kerosene, paint, paint thinners,
mothproofing substances, or
flammable dust
c) In an area with a space heater
d) Near fireplaces with unobstructed
entrances
20. Turn off the Wet/Dry Robot Floor
Cleaner before any adjustment, cleaning,
maintenance or troubleshooting. Note: in
the OFF (O) position, the robot still uses
a small amount of power.
21. Allow all filters to air-dry completely
before replacing in the Wet/Dry Robot
Floor Cleaner to prevent liquid from
being drawn into electric parts.
22. DO NOT modify or attempt to repair
the Wet/Dry Robot Floor Cleaner or the
battery yourself, except as indicated in
this manual. DO NOT use the vacuum if it
has been modified or damaged.
23. Remove all spilled or leaked liquid from
the dock landing mat, base or floor, as it
could lead to risk of electrical shock.
24. Try on an inconspicuous small area of
the floor, a little bit of the VACMOP™
cleaning solution to ensure it does not
affect the floor.
25. When refilling the reservoir, check for
leaks, as pooled liquids are a slipping
hazard and may cause electrical shock.
If the reservoir is damaged, it must be
replaced.
26. Use caution walking on mopped floors,
as they may be slippery while damp.
27. For your robot's cliff sensors to work
properly, all runners, rugs, carpets, or
small thresholds (like child gates) must
be 8 inches from any stairs (or must be
continuous and extend over the edge
of the stairs). If a runner, rug, carpet, or
small threshold that is less than 8 inches
from the stairs cannot be moved, you
must use a no-go zone or a BotBoundary
strip to block off the stairs. BotBoundary
strips are not included with your robot.
BATTERY USE
28. The battery is the power source for
the vacuum. Carefully read and follow
all charging instructions.
29. To prevent unintentional starting, ensure
the vacuum is powered off before picking
up or carrying the vacuum. DO NOT
carry the appliance with your finger on
the power switch.
30. Use ONLY the Shark® charging dock
XDCKRV2000 and use only battery
RVBAT850A. Use of batteries or battery
SAVE THESE INSTRUCTIONS
For the latest warnings and cautions, go to sharkclean.com/robothelp
chargers other than those indicated may
create a risk of fire.
31. Keep the battery away from all metal
objects such as paper clips, coins, keys,
nails, or screws. Shorting the battery
terminals together increases the risk of
fire or burns.
32. Under abusive conditions, liquids may be
ejected from the battery. Avoid contact
with this liquid, as it may cause irritation
or burns. If contact occurs, flush with
water. If liquid contacts eyes, seek
medical help.
33. Robotic vacuum cleaner should not be
stored, charged, or used at temperatures
below 50°F (10°C) or above 104°F
(40°C). Ensure the battery and vacuum
have reached room temperature before
charging or use. Exposing the robot
or battery to temperatures outside of
this range may damage the battery and
increase the risk of fire.
34. DO NOT expose the Wet/Dry Robot
Floor Cleaner or battery to fire or
temperatures above 265°F (130°C) as it
may cause explosion.
35. Non-rechargeable batteries cannot
be recharged.
NO-GO ZONES AND BOTBOUNDARY® STRIPS
36. DO NOT put BotBoundary strips
underneath carpet or rugs.
37. DO NOT place BotBoundary strips on
top of one another.
38. Always use no-go zones or BotBoundary
strips around reflective flooring and
surfaces.
39. No-go zones or BotBoundary strips
should always be used near carpeted
stairs.
40. DO NOT use no-go zones or
BotBoundary strips strips within 10 feet
of the dock.
41. For your robot's cliff sensors to work
properly, all runners, rugs, carpets, or
small thresholds (like child gates) must
be 8 inches from any stairs (or must be
continuous and extend over the edge
of the stairs). If a runner, rug, carpet, or
small threshold that is less than 8 inches
from the stairs cannot be moved, you
must use a no-go zone or a BotBoundary
strip to block off the stairs.
LASER WARNING
42. This product has a Class 1 laser. It is
safe under reasonably foreseeable
conditions (as defined in this Owner's
Guide.) Always turn off the power before
lifting the robotic vacuum cleaner or
performing any maintenance on it.
43. DO NOT look directly into laser.
s h a r kc l e a n . c o m