Tadiran Telecom SUV2-H18/1CFA-N Service Manual page 53

septum
Gas-liquid separator
Suction pipe
Procedure
13. Remove 4-way valve assy
Unsolder the spot weld of 4-way valve assy,
compressor and condenser, and then remove
the 4-way valve assy .
4-way valve assy
Discharge the refrigerant completely before
unsoldering,when unsoldering, wrap the gas
valve with awet cloth completely to avoid
damage to thevalve caused by high
temperature.
When unsoldering the spot weld, wrap the
4-way valve with wet cloth completely to avoid
damaging the valve due to high temperature.
14. Gas liquid separator and diaphragm
Open the suction of spot welding, remove the suction
pipe. Use a screwdriver unscrewed the fi xed screw of gas-
liquid separator, the upward gas-liquid separator, remove
the gas-liquid separator . Use screw knife clapboard and
chassis have fi xed screw drive, remove the partition .
Removal Procedure Removal Procedure
Note
Warning
49