Filling The Measuring Cup - Farmcomp Wile 65 Operating Instructions Manual

possible the entire lot of grain.
- Always take samples from different
places within the load. We recommend
taking at least five samples. Define
moisture content of the load by calculating
the average value of your five
measurements.
- Remove scrap, green and other
exceptional grains from the samples.
- When taking the sample directly from the
dryer wait until the temperature
compensation is done or pre-warm the
measuring cup with warm grain.
- Remember that the moisture inside the
load in the grain dryer varies until the final
stage of the drying process.

3.3. Filling the measuring cup

- fill the measuring cup one quarter with
grain (1)
- gently shake the meter (grains will settle
tighter in the measuring cup) (2)
- fill the measuring cup to the brim (3)
- wipe off excess grain (4)
- twist and tighten the cap until the center
of the cap is on the same level with the
cap's surface (5,6).
Important: Always fill the measuring cup
EN
7