Advertisement
Installation, operating and maintenance instructions
NOTE
Adjusting the gasket pressure
You can increase or reduce the gasket pressure using a Torx wrench T
Adjusting the gasket pressure at the
upper locking point on the locking side
(at the sash).
Adjusting the gasket pressure at other
locking points on the underside of the
sash.
Adjusting the gasket pressure at the
side of the sash at the top.
Installing the cover
It is advisable to adjust the Fold&Slide system before mounting the cover.
Also see chapter "Adjusting the Fold&Slide hardware" on page
Installing the cover of the pivot-rest
Plug the long cover onto the pivot-rest
( .).
Fasten the long cover by screwing in the
screw provided ( .) from the side.
Push the small cover at the bottom into
the pivot-rest until it snaps into place
( .).
, as shown below.
T
3
.
.
Installing the pivot-rest cover
T
T
.
.
7
Advertisement
