Advertisement
Installation, operating and maintenance instructions
NOTE
Installing the Fold&Slide sashes
As a prerequisite for installing the Fold&Slide sashes, the Fold&Slide sash
with frame hinges on the frame side must already be installed and correctly adjusted (for
more information see the corresponding profi le-specifi c installation drawing for Turn-Only or
Tilt&Turn hardware).
How to install a Fold&slide sash
Attach the Fold&Slide sash to be
mounted to the sash that is already
installed and push the hinges into one
another.
Insert the pins into the three sash
hinges from above or from below,
depending on the installation position
of the sash hinges (see illustration on
right).
The pins must noticeably engage.
Push the lower pivot-rest of the
Fold&Slide sash to be installed onto the
bogie ( ).
Tighten the locknut of the bogie
with the open-end spanner (size
to prevent the Fold&Slide sash from
slipping out ( ).
EN
Installing the pin in the sash hinge
Long side to the right
)
Long side to the left
.
.
1
Advertisement
