Hardware Adjustment - Lasita Maja Exeter 2 Manual

Hardware adjustment

TX 15
Tools not supplied!
Engaging and disengaging the stay
Adjusting the stay
Setting + 3,5 mm / -3 mm engage
TX 15
Adjusting the pivot rest
Setting 2 mm
±
TX 15
See additional document
"Installation, operating and maintenance instructions"
Vertical adjustment on bogie / pivot rest
Loosening and adjusting
- Hold the set bolt using an allen key
SW 4
+
- Loosen and hold the locknut using an
open-end spanner size 17
+3,5
- Adjust vertically with Allen key SW 4
-
Vertical adjustment
-1 Locking
+ 3,5 mm / -1 mm
- Hold the set bolt using an Allen key
SW 4
SW 4
- Firmly tighten locknut with open end
spanner size 17
Vertival adjustment on bogie and guide roll
Loosening and adjusting
- Hold the set bolt using an allen key
SW 4
+3,5
- Loosen and hold the locknut using
an open-end spanner size 17
Vertical adjustment
-1
+ 3,5 mm / -1 mm
- Adjust vertically with Allen key SW 4
SW 4
Locking
-
- Hold the set bolt using an Allen key
SW 4
- Firmly tighten locknut with open end
+
spanner size 17
SW 4
disengage
Setting ±1 mm
TX 15
Adjustment of the Turn-Only hinge
Adjustment at the rebate
corner-hinge
Adjustable
turn-brake
Setting ± 2 mm
SW 4
Setting ±1 mm
TX 15
-5 +1,5
Loosen
+2
screws for
-
-2
vertical
adjustment
-
+
Loosen screws for
horizontal adjustment
SW 4
Fixing / removing the sash hinge cover
For attachment / removal of sash-hinge covers, the
setscrews on the back must be tightened / loosened.
Open sashes to access screws, if the F&S unit is
already installed.
Setting 1 mm
±
TX 15
Setting + 3,5 mm / -3 mm
TX 15
Adjusting the pivot rest
Setting 2 mm
±
TX 15
+
SW 4
12