Advertisement
Installation, operating and maintenance instructions
Adjusting the Fold&Slide hardware
Adjusting the bogie and guide roll
The gap between the threshold and frame rebate and the gasket pressure of a Fold&Slide sash can be
adjusted at the bogie and guide roll. Please proceed as follows:
Move the Fold&Slide sash that is
already installed carefully into the
closed position.
Undo the locknut of the bogie on the
Fold&Slide sash to be adjusted using
the open-end spanner (size
Adjust the gap between the threshold
and frame rebate by turning the set
screw with a hexagon spanner (size )
so it corresponds to the dimension
specified in the installation drawing for
the specific profile (the set screw can
be adjusted from – mm to + . mm).
Adjust the gasket pressure by sliding
the pivot-rest.
Then tighten the locknut again with the
open-end spanner (size
) (tightening
torque:
Nm).
Undo the locknut on the guide roll
of the Slide&Fold sash to be adjusted
using the open-end spanner (size
Adjust the height of the guide roll by
turning the set screw with a hexagon
spanner (size ) so the guide roll
cannot scrape against the guide track
(adjustment range – mm to + . mm).
Adjust the gasket pressure by sliding
the pivot-rest.
Then tighten the locknut again with the
open-end spanner (size
) (tightening
torque:
Nm).
EN
)
).
3
Advertisement
