Advertisement
Installation, operating and maintenance instructions
NOTE
Checking the setting of the hinges
Each time you adjust the hinges, check afterwards that they are uniformly aligned!
Please proceed as follows:
Make sure that the test dimension shown
in the figure below is identical at all three
hinges of the sash.
If this is not the case, adjust the height of the
Fold&Slide sashes relative to one another
again at the set screw
until all three test
dimensions are exactly the same.
Test dimension
Make sure, using a straight edge or a long
spirit level, that the lateral edges of the
long sides of all three hinges on the sash
are flush.
If one of the hinges does not line up with the
other two, turn the adjusting screw
it does.
until
!
=
!
=
!
=
!
= 0
!
= 0
!
= 0
6
Advertisement
