Advertisement
Installation, operating and maintenance instructions
ATTENTION
Adjusting the sash hinges
The vertical position of the Fold&Slide sashes relative to one another and the size of the shadow gap
between the sashes can be adjusted at the hinges.
Adjustment
Hinge
range
/
- to + .
/ *
- to + .
* Adjusting plate turned through
Hinge in neutral position
You can adjust the vertical position of the Fold&Slide sashes relative to one another and also the
shadow gap between the sashes when installed by turning the set screws at the hinge (see fi gure
"Adjustment of the hinge" on page
Always make the adjustments at the set screws
If you undo all screws at once, this could damage the sash hinge!
Aligning the Fold&Slide sash vertically by turning the set screw
To align the Fold&Slide sashes vertically, proceed as follows:
Slightly loosen the two screws
Adjust the vertical position of the sliding panel by turning the set screw
Tighten the two screws
a
Neutral position ± on
base plate scale
distance between screws
. mm
. mm
°
5
):
and
a
so that the hinge and sash can move relative to one another.
again.
Distance between screws
, mm
one by one!
.
4
Advertisement
