Table of Contents
Advertisement
Wall Mounting the ScaleGard
(Mounting Template included with unit)
1. Draw a level line on the wall where the bracket is to be mounted. Hold bracket key holes on level line and mark locations for screws.
2. Install mounting screws (not included) into each of the initial key holes as shown in fi gure 2. Be sure to leave 1/8" to 1/4" (0.3 to 0.6 cm) space
between the bottom of the screw head and the wall so that the bracket can be hung. (assume system weight of 57 lbs. (25.9 kg))
To reduce the risk associated with property damage due to water leakage or fl ooding:
• Mount ScaleGard
TM
of installation. Ensure that the location and fasteners will support the weight of the system when installed.
• Allow a minimum of 3" (7.62 cm) clear space under fi lter to facilitate cartridge change.
3. Hang manifold from the mounting screws.
4. Once the bracket is hung, tighten the mounting screws so that the bracket is snug between the screw and the wall.
5. Install remaining mounting screws in locations as shown in fi gure 2.
Figure 2 — Installing Mounting Screws
HP Base Unit
TM
HP base unit in such position as to prevent it from being struck by other items being used in the area
MOUNTING HOLES
MOUNTING HOLES
NOTICE
IMPORTANT NOTES
8
MOUNTING HOLES
Operational weight - 57 lbs.
Advertisement
Table of Contents
