3M SGLP-CL Series Installation Manual
3M SGLP-CL Series Installation Manual

3M SGLP-CL Series Installation Manual

Reverse osmosis filtration systems

Advertisement

3M™ Water Filtration Products
Installation Manual
for SGLP-CL Series
Reverse Osmosis Filtration Systems
SGLP100-CL
SGLP100-CL-BP
Note: Installer - please leave with owner/operator.
Register your system and sign up for reminders at:
www.3m.com/FSfilterreminder
SGLP200-CL
SGLP200-CL-BP

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SGLP-CL Series and is the answer not in the manual?

Questions and answers

Summary of Contents for 3M SGLP-CL Series

  • Page 1 3M™ Water Filtration Products Installation Manual for SGLP-CL Series Reverse Osmosis Filtration Systems SGLP100-CL SGLP200-CL SGLP100-CL-BP SGLP200-CL-BP Note: Installer - please leave with owner/operator. Register your system and sign up for reminders at: www.3m.com/FSfilterreminder...
  • Page 2: Intended Use Statement

    Intended Use Statement: SGLP100-CL, SGLP200-CL, SGLP100-CL-BP and SGLP200-CL-BP are intended for use in filtering potable water and have not been evaluated for other uses. The products are installed at the point of use and must be installed as specified in the installation instruction by a qualified professional.
  • Page 3: Feedwater Parameters

    Turbidity ....<5 NTU For areas with high dirt/sediment in incoming water, HF60-CL or HF90-CL pre-filter is recommended. * NOTE: For waters over 10 grain hard, a 3M water softener is recommended for pretreatment. Consult 3M technical services for correct sizing.
  • Page 4: Product Specifications

    SGLP200-CL-BP Reverse Osmosis Water Filtration systems. Please unpack the contents from the product box and check to verify that all of the parts listed below are included. Should any parts be missing, please contact 3M Purification Inc. at 866.990.9785. DESCRIPTION...
  • Page 5: Plumbing Connections

    MOUNTING 1. See page 11, Figure 5 for mounting dimensions. 2. Install mounting screws (not included) into the wall or mounting surface as noted in Figure 5. Be sure to leave a 1/8” to 1/4” space between the bottom of the screw head and the wall so that the bracket can be hung.
  • Page 6 Water Valve (not included) Optional Service Loop Water Valve (not included) Inlet Water Inlet To Drain Water Sample Valve Water Valve (not included) Tank Shut-Off Outlet Valve To Equipment SGLP100-CL & SGLP100-CL-BP If installing cleaning bypass, please refer to page 13 Water Valve (not included) Optional Service Loop...
  • Page 7: System Start-Up

    HOW TO USE ‘PUSH-IN’ FITTING NOTICE To reduce the risk associated with water leakage or flooding: • Change the disposable pre-filter at the recommended interval; the disposable pre-filter MUST be replaced every 12 months or sooner. • Change the disposable filter RO membrane at the recommended interval; the disposable RO membrane MUST be replaced every 24 months or sooner.
  • Page 8 CARTRIDGE & RO MEMBRANE CHANGE INSTRUCTIONS Pre-filter Cartridge (Replace every 12 months) 1. Close tank shut-off. 2. Turn used pre-filter cartridge 1/4 turn to the left. 3. Pull down on cartridge. 4. Discard used cartridge. 5. Remove red cap from new cartridge and moisten the o-ring with water. 6.
  • Page 9 CHECK TANK PRESSURE WHEN: Yearly TOOLS: Piece of 3/8” tubing OR Bucket Bicycle or tire pressure gauge Bicycle tire pump 1. Drain water from the storage tank. a. Shut off the inlet water supply by removing the pre-filter or water booster system if applicable.
  • Page 10 56-12301 Tank THIS DOCUMENT CONTAINS PROPRIETARY, CONFIDENTIAL, DATE AND/OR PRIVILEGED INFORMATION WHICH IS THE PROPERTY ISSUED: OF 3M PURIFICATION INC. OR ITS DESIGNATED ENTITY AND IS SUBMITTED FOR USE ONLY IN CONNECTION WITH PROPOSED 60-235280 Tank Shut-off Valve AUTHORIZED WORK.
  • Page 11: Troubleshooting Guide

    Troubleshooting Guide Problem Cause Solution Notes Unit never Repair existing Contact Dealer produces RO Booster Pump Low Feed Water water/only Pressure Add Water Booster Only if Booster Pump provides bypass Pump is not installed. water Repair Existing Booster Pump / Contact Dealer System Low Feed Water...
  • Page 12 9" 3/8" 1/4" 3/4" 5/8" 10 1/2" Figure 5...
  • Page 13 IMPLIED WARRANTY OR CONDITION ARISING OUT OF A COURSE OF DEALING, CUSTOM OR USAGE OF TRADE. This warranty does not cover labor. If the 3M product does not conform to this warranty, then the sole and exclusive remedy is, at 3M’s option, replacement of the 3M product or refund of the purchase price.
  • Page 15 NOTES...
  • Page 16 Performance Data Sheet. 3M Purification Inc. 400 Research Parkway Meriden, CT 06450 USA Toll Free: 866.990.9785 3M is a trademark of 3M Company. Worldwide: 203.237.5541 All other trademarks are the property of their respective owners. Fax: 203.238.8701 34-8719-5112-4 www.3Mfoodservice.com...

Table of Contents