Graco IPH-25 Series Installation & Operation Manual page 21

Setup Screen #7: Enable/Disable Run
Screen Shot Editing or "Initiate Shot"
button
Enabling the "Initiate Shot" button allows starting and
stopping shots from both the gun and the "Initiate
Shot" button. When operating with the "Initiate Shot"
button enabled, the gun must be locked in a pouring
enclosure so that all dispensed material will be dis-
pensed in a direction away from people.
The system is shipped with the "Initiate Shot" but-
ton disabled.
To enable or disable Run Screen Shot Editing of the "Ini-
tiate Shot" button on the HMI, navigate to setup
screen #7 and push the top soft key. Confirm the selec-
tion when prompted. See Icons section on page 8.
Setup Screen #8: "Learn" Mode
See Learn Mode section on page 22.
Setup Screen #10: Define Piston Size
See Piston Size section on page 23.
Password Protection
The setup screens can be protected by a password to
restrict their accessibility. When the password is
"00000," the setup screens can be accessed without
entering a password.
To create a password to protect the setup screens or to
change the existing password, navigate to setup screen
#5 and hit the top soft key to enter the password entry
screen. Enter the new password twice and then hit the
top soft key to confirm.
To disable the password, change the password to
"00000" as described in the previous paragraph.
To access the setup screens when the password is
enabled, press the top soft key for three second and the
password entry screen will appear. Enter the password
and confirm to access the setup screens.
Entering a Password
Use the up and down arrow keys to change the selected
digit in the password. To move to the next digit, press the
top soft key. If a mistake is made, hit the bottom soft key
to exit password entry and then re-enter setup mode to
enter the password.
F . 12: Password Entry Screen
IG
Resetting Password
If the password is forgotten, the password can be reset
without losing the current machine settings or shot data.
1. Remove power from the shot controller for 10 sec-
onds.
2. Reapply power to the shot controller.
3. When the idle run screen appears, immediately
press and hold both the top soft key and up arrow
key for six seconds. The password will then auto-
matically be reset to "00000."
Setup
21