Graco IPH-25 Series Installation & Operation Manual page 15

Install Shot Controller
2
1
EA
F . 9
IG
24. Remove the two left side crown nuts (EA) from the
display (EC).
25. Apply thread sealant to threads of crown nuts (EA).
26. Install shot controller bracket (2) to display (EC)
using crown nuts (EA).
27. Snap shot controller (1) into shot controller
bracket (2).
Connect the Wire Harnesses
See Simplified Schematic, Shot Controller Wir-
ing on page 16.
CB
F . 10
IG
28. Remove electrical cabinet front cover (CB).
EC
EA
ti11758a
ti11756a
29. Connect the "pump" plug to J12 on the motor control
board.
30. Connect the "temp" plug to the "data" connector on
the temperature control board.
31. Connect wire harness to the linear sensor.
32. Connect 3-pin plug to J5 on the motor control board.
33. Connect 5-pin plug to J6 on the motor control board.
34. Connect the two power leads to the fan fuse block.
35. Replace electrical cabinet front cover (CB).
Connect Shot Controller Cables
See Simplified Schematic, Shot Controller Wir-
ing on page 16.
36. Plug DB25 data cable 15T859 into the receptacles
on the electrical enclosure cover (DB) and the shot
controller (1).
37. Plug power cable 121003 into the electrical enclo-
sure cover (DB) and the left receptacle on the shot
controller (1).
Conversion Kit Installation
15