Pitney Bowes DA Series Frequently Asked Questions Manual page 9

Select create a new form and fill in the material definitions. When done, press OK. This will make it
available to the printer as a material type.
1.1.19 Are there any daily maintenance actions I should take? (Both)
After any large run or before each shift of operation the paper path and sensors should be cleaned or blown
out.
If the printer begins to show jams without there appearing to be any cause for the jam, first try cleaning the
sensors to see if that corrects the problem.
1.1.20 Are there any restrictions about changing job settings? (Both)
If you are using an overlay, changing the Print Quality setting will cause the overlay to print incorrectly.
Changing the Print Quality setting during a job may cause one piece to be printed partially with the first
Print Quality setting and partially with the new Print Quality setting.
Changing any job setting in the middle of a job will cause the change to take affect immediately, usually
changing the appearance of the piece. Normal operation is to get the settings correct and checked before
starting the job.
1.1.21 Why is my barcode printing way above or below my address? (Both)
If the application is using blank lines before or after the address to position the address instead of either the
internal positioning elements, or direct WYSIWYG windows positioning, the extra blank lines are being
included in the address and the barcode is being positioned above or below the extra lines. In this situation,
remove the blank lines and change the positioning method to get the barcode to show in the proper location
relative to the address.
Page 9 of 37