Table of Contents
Advertisement
5.3 Firmware version indication:
The version of the installed firmware can be identified by pressing and holding down the buttons
In the upper display the letter F and a revision number is shown (e.g.
).
F
1.05
Key
enters the standard mode.
5.4 Reset the flow-meter to factory settings
It is possible to reset the flow-meter to factory settings. This effects that all stored data are set to
zero. The calibration factors are set to water like liquids.
The is presetting value for the Batch Controller is set to 5 L.
For resetting the flow-meter the mode for identifying the firmware version (s. 5.3) must be entered.
Now the reset could be done with
. After this the standard mode is selected.
Pressing
leaves the mode without changes.
Seite 7/8
Operation manual DR15
Rev 1.7e
16.10.06
Advertisement
Table of Contents
