Table of Contents
Advertisement
Figure 85. Installing the Mezzanine card on the PEM
Next steps
1. After installing the Mezzanine card on the system board,
2. Follow the procedure listed in the
Optional internal USB memory key
An optional USB memory key installed inside your sled can be used as a boot device, security key, or mass storage device. To
boot from the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in the
boot sequence in System Setup.
An optional USB memory key can be installed in the internal USB 3.0 port and can be used as a boot device, security key or
mass storage device.
The internal USB port is on the system board.
NOTE:
To locate the internal USB port on the system board, see the
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server module, the maximum permissible
dimensions of the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the
PEM.
install the
After working inside your sled
Safety instructions
Before working inside your sled
PEM.
section.
System board jumpers and connectors
section.
section.
Installing and removing sled components
section.
91
Advertisement
Table of Contents
