Table of Contents
Advertisement
Figure 31. 6 x 2.5 inch drive backplane
1. AUX 3 cable connector
3. I2C cable connector
5. AUX 1 cable connector
Figure 32. 8 x 2.5 inch drive backplane
1. AUX 4 cable connector
3. SATA/SAS connector
5. AUX 2 cable connector
7. Power cable connector [BP PWR]
Removing the drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, remove the drives from the sled before removing the
backplane.
CAUTION:
Note the number of each drive and temporarily label them before you remove the drive so that you
can replace them in the same locations.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air shroud from the
4.
Remove the
PEM.
5.
Remove all the
drives.
36
Installing and removing sled components
Safety instructions
Before working inside your sled
PEM.
2. SATA/SAS connector
4. AUX 2 cable connector
6. Power cable connector [BP PWR]
2. AUX 3 cable connector
4. I2C cable connector
6. AUX 1 cable connector
section.
section.
Advertisement
Table of Contents
