Table of Contents
Advertisement
2.2.
MTQ22-FBP
A device layout of the MTQ22-FBP can be seen in Figure 1. Connectors X1 ... X4 are used to
connect up to four FBP devices to the MTQ22-FBP. On the left side of the port connectors
LEDs show the current communication status. See chapter 5 for detailed information regard-
ing status LEDs.
Figure 1: Top view of the MTQ22-FBP. Four PSE devices can be connected to the MTQ22 via the
ports X1 to X4. The standard Micro USB connector X5 allows to configure the device.
The Micro USB connector X5 allows device configuration using a PC, see chapter MTQ22-FBP.
Two RJ45 sockets E1 and E2 offer Ethernet connectivity. The communication status of each
interface is shown by two LEDs. The MTQ22-FBP must be supplied with 24VDC via X6.
Mounting and Dismounting
You can mount and dismount the MTQ22-FBP onto a 35 mm standard mounting rail, without
tools.
Arrange the communication cables as far away from the motor cables as possible. Avoid par-
allel runs. Use bushings at cable entries. The network cable is connected to the RJ45 connect-
ors on the MTQ22-FBP module. Standard CAT5 UTP, FTP or STP cables can be used. The shield
of the RJ45 cable is connected to the shield of connector X6.
STATUS
Approved
© Copyright 2019 ABB. All rights reserved.
SECURITY LEVEL
Public
DOCUMENT ID.
1SFC132374M0201
F I ELD BU S CO MMU N ICAT ION
REV.
LANG.
PAGE
B
en
6/23
Advertisement
Table of Contents
