Table of Contents
Advertisement
3.2.
MTQ22-FBP
An easy to use PC configuration tool is provided to adjust the parameters of the MTQ22-FBP.
The PC can be connected to the MTQ22-FBP with a standard Micro USB-cable. The ABB Con-
figuration Tool can be downloaded by clicking the following
1SAJ260900R0001 at the ABB Download Center.
Figure 4: Connecting the MTQ22-FBP to a service Laptop. The MTQ22-FBP must be supplied
with 24V DC before the configuration can take place (1). For the connection a Micro USB cable
(2) is used. On the PC the MTQ22-FBP configuration software must be installed (3).
If the MTQ22-FBP is connected for the first time the required USB driver has to be installed.
The Microsoft USB driver is not part of the software package because of license reasons. It is
pre-installed on Windows 7 and 10, for XP it must be downloaded separately from Microsoft.
Follow the setup instructions of Windows to install the new software. After startup of the ap-
plication the screen is split into three areas - left, middle and right. In the left area you can
add as many MTQs as you have in your project. In the middle area the configuration parame-
ters per MTQ22-FBP are displayed. You can change them offline or online. The right area
shows a short help text.
Make sure to start the Configuration Tool as administrator and to connect the USB cable be-
tween the PC and MTQ22-FBP before the program is started.
STATUS
Approved
© Copyright 2019 ABB. All rights reserved.
SECURITY LEVEL
Public
link
DOCUMENT ID.
1SFC132374M0201
F I ELD BU S CO MMU N ICAT ION
or searching for
REV.
LANG.
PAGE
B
en
11/23
Advertisement
Table of Contents
