Table of Contents
Advertisement
5. When all Expected device parameters for FBP Device 1 to 4 are adjusted click the Write to
MTQ22-FBP button to upload the configuration to the device.
6. Select the FBP Devices in the Config Tool and set the expected Device address to match
the Device address read by the MTQ22-FBP. When the two Device addresses match for all
connected PSEs click the Write to MTQ22-FBP button again. Note that, when the slave ID is
updated in the PSE a reboot will be required on the PSE for the Config Tool to the detect
the new value.
7. The MTQ22-FBP is now configured and should be able to communicate with the PSE.
STATUS
Approved
© Copyright 2019 ABB. All rights reserved.
SECURITY LEVEL
Public
DOCUMENT ID.
1SFC132374M0201
F I ELD BU S CO MMU N ICAT ION
REV.
LANG.
PAGE
B
en
14/23
Advertisement
Table of Contents
