Remove The Workstation From A Z Or Ez Console - Honeywell T5810XL Planning, Installation And Service Manual

Chapter 5 - Servicing
5.1.2

Remove the workstation from a Z or EZ Console

If the workstation is mounted in the Z or EZ Console, remove it from the furniture before servicing.
To remove the workstation from a Z or EZ Console
1. From the rear of the console, loosen the fasteners and remove the rear cover.
2. The electronic module sleeve is held in place by detents on the top and bottom of the cover, near
the back edge. Lift the back edge of the cover slightly to allow the top detents to clear the top of the
workstation. You may have to push down on the bottom of the cover as you slide it toward you and
off the workstation.
3. Disconnect the cables that are connected to the back panel connectors of the workstation. Do not
disconnect the peripheral ends of the cables unless specifically instructed to do so. Tag the cables
so that they can be properly reconnected to the workstation.
- 69 -