Installing Optional Components - Honeywell T5810XL Planning, Installation And Service Manual

Chapter 3 - Installing
8. Ensure you insert the side spacer assembly on both sides of the workstation.
9. Push the side spacers in until the handle is flush with the front flange of the side mounting brackets.
10. Replace both the left and right front retaining brackets. Position the stop peg covered with Vinyl cap
such that it is in contact with the front bezel on the left side and the front bezel handle on the right
side. Tighten the hex threaded standoff to lock each stop peg in place.
11. If other workstations are not installed, go to the section,
3.9

Installing optional components

Honeywell provides a number of other options that may be installed in the cabinet with your
workstation. Each of the following options is packaged with installation instructions.
Component Description
OEP/IKB
adapter
Used for connecting an OEP or IKB that uses an ISA connection to the
workstation's serial port. Refer to Honeywell Peripheral Adapters
(ADP01)
Connecting cables.
- 47 -