Honeywell T5810XL Planning, Installation And Service Manual page 34

6. Install the left retaining bracket over the lower edge of the side mounting rail as displayed in the
figure. Make sure the distance between the back panel of the workstation and the lip of the rear
cover retaining bracket is five (5) inches as illustrated in the previous image.
7. Secure the right and left bracket by tightening the M5 hex locknut as illustrated in the following
image.
8. Route the interface cables into the cable management area at the rear of the workstation. The
following image illustrates how interface cables are terminated to their respective connectors on
the rear of the workstation chassis. Any excess length is managed in the 127 mm [5 inch] space
behind the chassis.
- 34 -
Chapter 3 - Installing