Table of Contents
Advertisement
6. Hold the lens unit firmly and slide the lock lever to the right until it clicks, indicating that it is locked.
Note: You can tighten the screw by hand to secure the lever.
7. Replace the lens cover.
8. Do one of the following:
• If you attach a lens that is different from the previous lens, you see a message to calibrate the lens
the next time you turn on the projector. Select Yes to calibrate the lens.
• If you remove and attach the same lens, press and hold the Default button or select Lens
Calibration in the Extended menu to calibrate the lens.
Lens calibration takes up to 3 minutes to complete. When calibration is finished, the lens returns to
its previous position.
Caution: If you see a message that lens calibration failed, remove the lens and reinstall it. If the
message still appears, turn off the projector, unplug the power cord, and contact Epson.
If the projector cannot determine the model number of your lens, you cannot perform lens
calibration.
Parent topic:
Related references
Projector Setup Settings - Extended Menu
Removing a Lens
You can remove a lens to replace it with a different lens.
Attaching and Removing a Lens
61
Advertisement
Table of Contents
