Table of Contents
Advertisement
When setup is complete, you see a screen like this:
Note: If any of the images are not positioned correctly, set up tiling manually instead.
12. Select the input signal to display an image.
After performing the steps here, adjust the images for any gaps and differences in color.
Note: Do not change any of the projector names or IP addresses, or the images will not be adjusted
automatically.
Parent topic:
Related tasks
Configuring Tiling Manually
Configuring Tiling Manually
If your projectors are not on a network or you were unsuccessful tiling the images automatically, you can
configure tiling manually.
1. Turn on the projector.
2. Press the Menu button.
3. Select the Extended menu and press Enter.
Tiling Images into One Image
201
Advertisement
Table of Contents
