Table of Contents
Advertisement
Caution: Remove the lens only when necessary and make sure the front of the projector is not facing up
when you remove the lens. This prevents dirt or dust from entering the projector and lowering the
projection quality. Avoid touching the lens with your bare hands to prevent fingerprints on or damage to
the lens surface.
1. Center the lens using the Lens Shift button.
2. Turn off the projector and unplug the power cord.
Warning: Wait approximately 30 minutes after turning off the projector before removing the lens.
Touching the lens immediately after projecting or turning off the projector may cause burns.
3. Loosen the lens cover screws by hand.
4. Press the tabs on both sides of the lens cover and pull the lens cover off the projector.
5. Hold the lens unit firmly as you slide the lock lever to the left.
Caution: Avoid touching the areas shown here or you may damage the lens unit.
Note: If you tightened the locking screw, loosen the screw first.
6. Gently pull the lens straight out of the projector.
Parent topic:
Attaching and Removing a Lens
62
Advertisement
Table of Contents
