Fe6600 And Bl6600 Series Multi-Point Locks - Assa Abloy Corbin Russwin FE6600 Series Installation Instructions Manual

FE6600 and BL6600 Series
Multi-Point Lock
Installation Instructions
3 Installation (continued)
c

FE6600 and BL6600 Series Multi-Point Locks

Important:
Check template 4740 to prep door for function holes, size and location.
1. Verify strike location according to template.
2. Clean out door pocket and door edge of debris.
3. Make sure handing of lock (latch and locking piece)
match handing of door.
4. Slide lock into door and hold.
5. Slide outside lever and rose assembly (or lever and escutcheon
assembly) through the door; lockbody and hold.
Note:
• Keep door open while installing lock. If installing lever onto
only one side of the door, see separate instruction sheet.
• Assemble keyed cylinder through narrow end of spring
and wider opening of collar (or escutcheon).
• Assemble onto door by threading into lock until cylinder face is flush
with collar edge. Pulling key slightly out of cylinder will help when
threading cylinder inward.
Note:
Corbin Russwin logo must be horizontal and on upper portion of cylinder face.
6. Tighten cylinder clamp screw (#2 Phillips screwdriver).
7. Secure lock in door with two (2) wood screws (#12 x 1-1/4") or machine screws (#12-24 x 1/2").
Do NOT tighten completely at this time .
8. Slide spindle into lockbody hub.
9. Slide adapter and plate assembly over spindle and secure
with two (2) #8-32 screws.
10. Screw rose firmly onto adapter and plate assembly
(or attach escutcheon).
11. Attach inside lever and secure with 1/8" Allen wrench.
Verify lock is operating correctly prior to closing door.
12. Assemble thumbturn/emergency release (if provided)
according to instructions on bag.
13. Check for proper lock operation prior to closing door.
14. Tighten two (2) lockbody screws completely. Attach outside
front using two (2) #8-32 x 1/4" flat head screws.
Note:
Removable core or interchangeable core cylinders require a control key (key stamped with C) to remove
and install the inner cylinder core.
• This is not standard and must be requested separately.
• If requesting 1-bitted control key, specify 113511 cut.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2019, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Outside of Door
1
RH Door Shown
2
Figure 6
Outside of Door
6
5
8 7
Figure 7
10
9
13
Figure 8
5
3
4
FM468 03/20