Connection - Sunrise Medical PowerTalk2 User Manual

3

Connection

Connect the WheelDrive with a USB cable (mini to normal) to your pc and switch on the WheelDrive.
Start PowerTalk.
When PowerTalk updates are available, you will be asked to update the software.
A start-up screen will be opened.
1. This field gives information about the registered user of PowerTalk and the applicable User Level. Functionality
of PowerTalk 2 depends on User Level and the esense system configuration. The highest User Level described
in this manual is L3. When a setting is only available in level 3 or level 4, this will be indicated by: [L3] or [L4]
2. This field gives information about the USB connection status (left) and the WIFI connection (right)
3. By pressing this button, you connect the WheelDrive to PowerTalk
Note: When connecting a new WheelDrive to PowerTalk for the first time, you will be prompted to fill in a new
system name. The information that PowerTalk collects during the session will be stored on the local hard disk of the
pc that is connected and this name will be used.
When the same WheelDrive is connected again, the information will automatically be stored and the pop-up box
below will not show up again.
PowerTalk2 User Manual - E1801_20181018 Rev.A 7