Introduction - Sunrise Medical PowerTalk2 User Manual

Table of Contents

Introduction

This document describes all parameters available in the 'WheelDrive' Generation 2019 software. These parameters

can be monitored, changed or reset with PowerTalk 2.

Notice!

For full functionality the WheelDrive motor controller must be programmed with Main controller firmware version:

2.172 (or later).

All parameters are grouped in 'function blocks' in PowerTalk. Availability of function blocks depends on the system

type configuration. This configuration is defined by the product connected to the system.

Function Block

WheelDrive System

WheelDrive Firmware

WheelDrive General

WheelDrive UI

WheelDrive

Battery

The right to change or reset parameters under the tabs settings and counters is defined by the Powertalk license

key. Three levels are defined; for end-users, service engineers and system integrators.

•

L1 - License for end-users. No rights to change or reset parameters.

•

L2 - License for regular service engineers. Right to change a limited number of settings and counters.

•

L3 - for certified service engineers and system integrators. Right to change an extensive number of settings

and counters.

The table in chapter 4 lists what level is required to change a setting. Please contact

info@esense-moves.com for information on availability and pricing of Powertalk license keys.

WheelDrive Parameter List - E1801_20181018

Availability

WheelDrive gen 2019

All systems with batterypack

Rev.A

Table of Contents

Wheeldrive