Care And Maintenance; Cleaning The Pre_Filter And Filter Holding Area; Changing The Filters - ElectrIQ EAP300PM2.5HC User Manual

• Always shut off the unit and unplug from the mains before cleaning or performing any
maintenance.
• When the unit is not in use for long periods, it is advisable to remove the plug from the
power socket.
• Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage to the unit.
CLEANING THE PRE-FILTER AND FILTER HOLDING AREA
The pre-filter should be vacuumed every 2-3 weeks to
remove any debris which has accumulated on it, while
cleaning the pre filter, the filter holding area should also
be wiped with a dry cloth. If used in dustier
environments the pre-filter may require more regular
cleaning. For a deeper clean the pre-filter can be
removed and rinsed in clean water and then left to dry
naturally. Ensure the pre-filter is fully dry before
reinserting into the unit. The pre-filter must be replaced
if there are any signs of damage.

CHANGING THE FILTERS

Remove and replace the filters following the
instructions found on Page 8. Once the filters have
been replaced, press and hold the RESET button for
5 seconds to reset the filter counter.

CARE AND MAINTENANCE

11