Advertisement
f TALLY switch
Controls the TALLY indicator (page 25) located on the
front of the viewfinder.
HIGH: The tally indicator brightness is set to high.
OFF: The tally indicator is disabled.
LOW: The tally indicator brightness is set to low.
g ENTER switch
Selects and enters menu items.
For details on the menu operations, see "Using the Menu"
on page 35.
h MENU switch
Displays the menu.
For details on the menu operations, see "Using the Menu"
on page 35.
i ZEBRA (zebra pattern) switch
Controls the zebra pattern display on the viewfinder screen
as follows:
ON: A zebra pattern appears and stays.
OFF: The zebra pattern disappears.
MOMENT: A zebra pattern appears and stays for about 5
seconds.
j ASPECT/DISPLAY switch
Turns the marker indication on and off, and switches
between 4:3 and 16:9 aspect ratios for viewfinder screen
display.
ASPECT: Each push of the switch to this position toggles
the mask display on and off.
DISPLAY: When the marker indication is enabled with
the camera, the marker indication on the viewfinder screen
turns on and off every time you push the switch to this
position.
Indicators on the LCD Screen
Indicators are located on the upper and lower parts of the
LCD screen to indicate the status of the camera and the
operating status of the magnification function.
1 Green tally indicator
7
indicator
a Green tally indicator
Light up when the camera receives a green tally signal
from a camera control unit.
b TALLY/REC (red tally/recording) indicator
Lights in red or flashes, to indicate the following.
Lit: Recording, or reception of a tally signal from a camera
control unit.
Flashing: The VTR attached to the camera is not servo-
locked.
c BATT (battery) indicator
Lights up or flashes, to indicate the status of the battery
attached to the camera as follows.
Lit: The battery is drained.
Flashing: The voltage of the battery has dropped below
the threshold value.
To prevent camera from shutting down, change the battery
as soon as possible after this indicator begins flashing.
The threshold battery voltage value at which this indicator
begins flashing can be set by the camera. For details, refer
to the manual for the camera.
d SAVE (VTR power save) indicator
Light up when the VTR attached to the camera is in power-
saving mode.
e Spare indicator
Available in near future.
f MAG (magnification) indicator
Lights up when the image is magnified by using the
ASSIGN 2 switch (factory-setting) or the ASSIGN 1
2 TALLY/REC
indicator
3 BATT
indicator
Image
4 SAVE
indicator
5 Spare
indicator
6 MAG
indicator
Location and Function of Parts
27
Advertisement
Chapters
