Disc Brake Inspection [Depending On Models] - Sym Jet Euro X 50 Manual

11. INSPECTION AND MAINTENANCE BEFORE RIDING
DISK BRAKE INSPECTION
Visual Inspection for leakage or damage. If
there is any, take your scooter to SYM
Authorized Dealer or Franchised Dealer for
a check or repair.
Park the motorcycle on a level ground, and check if fluid level is under the "LOWER" mark.
Recommended Brake Fluid: WELL RUN BRAKE OIL (DOT 3).
Lower limit
Viewing window
Check the brake from behind the brake
caliper. The brake pad must be replaced
with new lining when the brake pad wear
limit reaches the brake disk.
【ADDING BRAKE FLUID】
1. Loosen the screws and remove the master
cylinder cover.
2. Wipe clean foreign materials, dirt around the
reservoir, being careful not to let foreign
materials fall into the reservoir.
3. Remove the diaphragm plate and the
diaphragm.
4. Add brake fluid to upper level.
5. Install the diaphragm plate and the diaphragm,
and install the master cylinder cover.
6. Please note the diaphragm direction, and do
not let foreign materials fall into the reservoir.
And tighten the master cylinder cover securely.
CAUTION:
Do not fill brake fluid past the upper limit of the brake fluid reservoir. Avoid spilling brake fluid on
painted or plastic components.
[Applicable for model equipped with disc brake.]
23
Hose connection
Lower limit
Viewing window
Master cylinder
cover
Upper
Brake pad wear
limit grooves
Brake disk
Brake caliper
Screw
Diaphragm
Brake fluid