Table of Contents
Advertisement
7.3
Relay
The relay functionality is parametrized in the Config file.
Relay modes
OFF
Alarm roof
Alarm Monitor
Alarm Roof
and Monitor
Temp One setpoint
Temp Two setpoints
For more info on Alarm's, see chapter 7.5 diagnostics
The parameters for the Temp modes, can be parametrized in the config file, see Appendix 13.
Appending on the application, 1 or 2 set points can be selected, see below.
Default mode
Blocked drain, Blocked sensor
Low battery, Lost connection, Internal leak
Blocked drain, Blocked sensor, Low battery, Lost connection,
Internal leak
For application where only one setpoint is needed
For application where two setpoints are needed
Hysteresis = 1C°
Setpoint 1= 4 C°
Hysteresis = 1C°
Setpoint 1= 4 C°
Setpoint 2 =2 C°
REV. 01 - OCTOBER 2020 - BLÜCHER
17
CONNECTED ROOF
®
Advertisement
Table of Contents
