Miele PG 8063 Operating Instructions Manual page 16

Warning and Safety instructions
16

In critical applications where very stringent requirements have to
be met, it is strongly recommended that all the relevant factors for the
process, such as chemical agents, water quality etc. are discussed
with the Miele Application Technology specialists.

Load carriers which hold the load items must be used only as in-
tended.
Lumened load items must be thoroughly cleaned, internally and ex-
ternally, with the wash water.

Place small and light items in a small-part basket so that they do
not block the spray arms.

The amount of residual solvents and acids on items going into the
cabinet should be minimal.
There should be no more than a trace of any solvents with a flash
point of below 21 °C.

Chlorous solutions, in particular hydrochloric acid, must not be
placed in the cabinet.

Ensure that solutions or steam containing chlorides or hydrochloric
acid do not come into contact with the stainless steel outer casing of
the machine in order to avoid any damage through corrosion.

After any plumbing work the water pipework to the machine will
need to be vented. If this is not done, components can be damaged.

The gaps between a built-in machine and adjacent cabinetry must
not be filled e.g. with silicone sealant as this could compromise the
ventilation to the circulation pump.

Follow the installation instructions in the operating and installation
instructions.