Noises - Miele PG 8063 Operating Instructions Manual

Problem solving guide
Problem
Check drainage

Noises

Problem
Knocking noise in the
wash cabinet.
Rattling noise in the wash
cabinet.
Knocking noise in the wa-
ter pipes.
108
Cause and remedy
A programme was cancelled because the water in the
wash cabinet is only being pumped away slowly or not at
all.
- The drain hose is blocked.
Remove any kinks or large loops in the drain hose.

Start the programme again.

- The filters in the wash cabinet are blocked.
Clean the filters in the wash cabinet.

 Danger of injury from sharp or pointed objects re-
tained in the filters.
Start the programme again.

- The drain pump or the non-return valve is blocked.
Clean the access to the drain pump and the non-return

valve.
Start the programme again.

- The drainage system cannot take in enough water be-
cause it is blocked.
Contact a qualified installer.

Cause and remedy
One or more spray arms are knocking against the wash
load.
Cancel the programme. To do this follow the instructions

in "Cancelling a programme".
Arrange the wash load so it cannot obstruct the spray

arms.
Make sure the spray arms can rotate freely.

Start the programme again.

Items are insecure in the wash cabinet.
Cancel the programme. To do this follow the instructions

in "Cancelling a programme".
Rearrange the load so that items are secure.

Start the programme again.

This may be caused by the on-site installation or the cross-
section of the piping. It has no influence on the function of
the machine.
Contact a suitably qualified plumber.
