Messages; Table 9-1: Pyrometer Parameters; Table 9-2: Messages - Fluke Endurance Series User Manual

®
Endurance Series
Users Manual, Rev. 2.0, Jun 2020
Temperature unit
Color mode
Slope
Emissivity
Transmissivity
Sensor offset
Sensor gain
Averaging time
Valley hold time
Peak hold time
Setpoint relay
Deadband
Decay rate
Relay alarm output control
Laser control
Panel lock
Analog output mode
Bottom temperature of output
Top temperature of output

9.3 Messages

Message diagnostics alarm
Message process alarm
Behavior on module fault
68

Table 9-1: Pyrometer Parameters

Parameter
Parameter
The diagnostics information of pyrometer is not
transferred to the PROFINET IO controller
is transferred to the PROFINET IO controller
The process alarm of pyrometer is not transferred
to the PROFINET IO controller
is transferred to the PROFINET IO controller
Description
Set the temperature unit
* 1000 (0.9 → 900)
* 1000 (0.9 → 900)
* 1000 (1.0 → 1000)
* 0.1 s (1 s → 10)
* 0.1 s (1 s → 10)
* 0.1 s (1 s → 10)
in °C /°F
Set output mode
Set bottom temperature of analog output
Set top temperature of analog output

Table 9-2: Messages

Description
Setting
Celsius
Fahrenheit
1 , 2 color
850 ... 1150
100 ... 1100
100 ... 1100
-200 ... +200
800 ... 1200
0 ...3000
0 ...3000
0 ...3000
dev. range min. max
1 ...99
0 ...9999
normally open,
normally closed,
permanently open,
permanently closed
off / on / flashing / trigger
locked / unlocked
0 ... 20 mA / 4 ... 20 mA
0...9999°C /°F
0...9999°C /°F
Setting
message inactive
message active
message inactive
message active
set process data to zero,
set process data to last value