Table of Contents
Advertisement
SPA2-2 installation guide
www.renishaw.com
8. Locate the 4th axis card onto the pillar mounts using the M3 screws supplied. Do not tighten these screws.
9. Using the jackscrews supplied, secure the 4th axis card connector through the location hole in the rear panel of the SPA2-2. Tighten the
jackscrews (taking care not to overtighten) and then tighten the screws fitted in step 7.
10. Fit the communication cable attached to the SPA2-2 motherboard to the 4th axis interface card, as shown in the diagram above.
11. Fit the voltage supply cable loom from the SPA2-2 to the 4th axis option card, as shown in the diagram above.
12. Refit the lid by reversing the procedure in step 3 and replace the plastic bungs.
Issued 11 2020
31
Advertisement
Table of Contents
