Maximum Retention Time; Recording Scheduler - Bosch AUTODOME IP starlight 5100i User Manual

AUTODOME IP starlight 5100i
If the target has not yet been defined, click Configure accounts to jump to the Accounts page
where the server information can be entered.
Alarm triggers *
Select the alarm type that is to trigger an alarm recording:
–
–
–
Select the Virtual alarm sensors that are to trigger a recording, via RCP+ commands or alarm
scripts, for example.
8.4

Maximum Retention Time

Recordings are overwritten when the retention time entered here has expired.
4
Make sure that the retention time does not exceed the available recording capacity.
8.5

Recording Scheduler

The recording scheduler allows you to link the created recording profiles with the days and
times at which the camera's images are to be recorded in the event of an alarm.
You can link any number of 15-minute intervals with the recording profiles for each day of the
week. Moving the mouse cursor over the table displays the time below it. This aids orientation.
In addition to the normal weekdays, you can define holidays that are not in the standard
weekly schedule on which recordings are to apply. This allows you to apply a schedule for
Sundays to other days with dates that fall on varying weekdays.
Weekdays
Assign as many time periods (in 15-minute intervals) as needed for any day of the week. Move
the mouse cursor over the table - the time is displayed.
1.
2.
3.
4.
5.
6.
Holidays
You can define holidays that are not in the standard weekly schedule on which recordings are
to apply. This allows you to apply a schedule for Sundays to other days with dates that fall on
varying weekdays.
1.
2.
3.
4.
5.
Deleting Holidays
You can delete holidays you have defined yourself at any time.
1.
Bosch Security Systems
Alarm input
Analysis alarm
Video loss
Enter the required retention time in days for each recording track.
Click the profile to be assigned in the Time periods box.
Click a field in the table and, while holding down the left mouse button, drag the cursor
across all of the fields to be assigned to the selected profile.
Click the No recordings profile in the Time periods box to deselect the intervals.
Click Select All to select all of the intervals to be assigned to the selected profile.
Click Clear All to deselect all of the intervals.
When finished, click Set to save the settings to the device.
Click the Holidays tab. Any days that have already been selected will be shown in the
table.
Click the Add button. A new window will open.
Select the desired date from the calendar. You can select several consecutive calendar
days by holding down the mouse button. These will later be displayed as a single entry in
the table.
Click OK to accept the selection. The window will close.
Assign the individual holidays to the recording profiles, as described above.
Click the Delete button. A new window will open.
User Manual
Recording | en 49
2020-11 | draft 0.9 |