Mark both Hammers on the same end. LUBRICATION 2. With mechanism sitting upright on a workbench, Each time a Series 2906P Impactool is disassembled for slowly rotate Anvil in a clockwise direction until it maintenance and repair or replacement of parts, lubricate comes up solid.
3. If Motor Clamp Washers (39) remained in Housing, 4. Install Throttle Valve Spring (9), small end first. remove them. If Washers remained with motor, lift 5. Make certain two Oiler Body Seals (12) are positioned them off Front End Plate (37). in annular grooves on the Oiler (10) and install Oiler, 4.
Page 4
15. Secure Housing Cover with Housing Cover Cap 2. Replace Hammers in Hammer Frame (41) exactly as Screws (26 and 27) and Lock Washers (28). Tighten they were when you marked them prior to disassembly. Screws to 50 to 60 in–lb (5.6 to 6.8 Nm) torque. Install the two short Cap Screws (27) in the holes If you are installing new Hammers, or want to farthest from the Air Inlet and the two long Cap...
TROUBLESHOOTING GUIDE Trouble Probable Cause Solution Low power Dirty Inlet Bushing or Air Using a suitable cleaning solution, in a well Strainer Screen and/or Exhaust ventilated area, clean Air Strainer Screen, Inlet Silencer Bushing and Exhaust Silencer. Replace complete set of Vanes. Worn or broken Vanes Worn or broken Cylinder and/or Examine Cylinder and replace it if it is worn or...