Dimplex Prism Series Owner's Manual page 18

Operation
C. Heat ON/OFF
Cycles the unit sequentially
through the 3 settings: Low Heat,
High Heat and Off.
→ Activated by pressing the
button on the unit or the
remote.
• Indicated by the
the intake temperature being
displayed on the On-Screen
Display, for 5 seconds before
turning off.
! NOTE: After the heater is
switched off, there is a 60
second fan delay, where the
fan will continue running before
turning off.
! NOTE: The unit can be
operated in Heat Only Mode.
When the unit is only running
with the heater, the
continuously be displayed on
the On-Screen Display.
! NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial
heating of internal heater parts
and will not occur again.
18
icon and
icon will
D & E. Thermostat
Controls
Adjusts the temperature setpoint
to your individual requirements.
Once the desired set temperature
is reached, the heater will turn
off. The heater will cycle on
and off to maintain the desired
set temperature. The default
temperature setting is 72°F
(22°C).
→ Adjusted by pressing the
to decrease the setpoint and
the to increase the setpoint
on the unit or the remote.
• The On-Screen Display will
indicate the temperature
setpoint as it is adjusted.
! NOTE: Holding the
and the
manual controls down for
two seconds, will change the
temperature from °C to °F, or
vice versa.
buttons on the
www.dimplex.com