Wireless (Wi-Fi) Setup; Wifi Setup Using App - Cary Audio Design DMS-700 Owner's Manual

WIRELESS (WI-FI) SETUP

IF YOU ARE CONNECTING THE DMS WITH WI-FI,
you have an active wireless home network and router installed in your home. The quality and stability of the audio signal
depends on the bandwidth and range of your Wi-Fi router. This is especially true for exceptionally high-resolution files,
such as DSD files or PCM files greater than 192kHz. When possible, a wired (Ethernet) connection is preferred.

WIFI SETUP USING APP

Before proceeding, have the Cary Audio Streamer app downloaded to your phone, but NOT opened.
1. Place the DMS-700 anywhere within the routers Wi-Fi range. Make sure BOTH Wi-Fi antennas are connected. (Do
NOT connect the Ethernet cable).
2. Turn on the DMS-700. If the below screen does not appear, press Network input source on IR handheld remote.
3. Use the IR handheld remote to select "Connect to Wi-Fi with App".
4. Once selected or if no action is taken within 30 seconds, the DMS-700 will open a Wi-Fi Hotspot called "DMS-Wifi".
Make not of the password; 12345678.
5. Open your phones WIFI setup Menu and connect to DMS WiFi.
6. Once connected to DMS WiFi, open the Cary Audio Streamer app and following the prompts to "Setup a new
DMS".
7. After following the onscreen instructions on your phone and you have successfully connected the DMS-700 to your
home Wi-Fi network, check your phone's WIFI setup Menu to make sure the phone has reconnected back to your
home Wi-Fi network.
DO NOT CONNECT THE ETHERNET CABLE . This step assumes
30