Storage; Electrical Connection; Disposal And Recycling - Scheppach SD1600V Translation From The Original Instruction Manual

GB

10. Storage

Store the device and its accessories in a dark, dry
and frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and
30˚C. Store the electrical tool in its original packag-
ing.

11. Electrical connection

The installed electric motor is completely wired ready
for operation.
The customer's connection to the power supply sys-
tem, and any extension cables that may be used,
must conform with local regulations.
Important remark:
The motor is automatically switched off in the event
of an overload. The motor can be switched on again
after a cooling down period that can vary.
Defective electrical connection cables
Electrical connection cables often suffer insulation
damage.
Possible causes are:
Pinch points when connection cables are run
•
through window or door gaps.
Kinks resulting from incorrect attachment or laying
•
of the connection cable.
Cuts resulting from running over the connecting
•
cable.
Insulation damage resulting from forcefully pulling
•
out of the wall socket.
Cracks through aging of insulation.
•
Such defective electrical connection cables must not
be used as the insulation damage makes them ex-
tremely hazardous.
Check electrical connection cables regularly for
damage. Make sure the cable is disconnected from
the mains when checking.
Electrical connection cables must comply with the
regulations applicable in your country.
Single-phase motor
The mains voltage must coincide with the voltage
•
specified on the motor's rating plate.
Extension cables up to a length of 25 m must have
•
a cross-section of 1.5 mm
least 2.5 mm .
2
The connection to the mains must be protected
•
with a 16 A slow-acting fuse.
Only a qualified electrician is permitted to connect
the machine and complete repairs on its electrical
equipment.
22 / 172
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
, and beyond 25 m at
2
In the event of enquiries please specify the fol-
lowing data:
Motor manufacturer
•
Type of current of the motor
•
Data recorded on the machine's rating plate
•
• Data recorded on the switch's rating plate
If a motor has to be returned, it must always be dis-
patched with the complete driving unit and switch.

12. Disposal and recycling

The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materials
in this packaging can be reused or recycled. Never
place batteries in your household refuse, in fire or in
water. Batteries should be collected, recycled or dis-
posed of by environment-friendly means. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste elec-
trical and electronic equipment. Improper handling
of waste equipment may have negative consequenc-
es for the environment and human health due to po-
tentially hazardous substances that are often con-
tained in electrical and electronic equipment. By
properly disposing of this product, you are also con-
tributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.